BOTTLE BLOWING MACHINE is a bottle blowing machine that can heat, blow and shape PET preforms into plastic bottles of various shapes. Its working principle is to heat and soften the preform under the irradiation of infrared high-temperature lamp, then put it into the bottle blowing mold, and blow the preform into the required bottle shape with high-pressure gas.
The maintenance of BOTTLE BLOWING MACHINE mainly has the following five points for attention:
1. Regularly check all parts of the bottle blowing machine, such as motors, electrical appliances, pneumatic components, transmission parts, etc., for damage, looseness, air leakage, electric leakage, etc., and replace or repair them in time.
2. Regularly clean the dust, oil, water stains, etc. of the blow molding machine, keep the blow molding machine clean and dry, and prevent corrosion and short circuit.
3. Regularly add oil to the lubricating parts of the blow molding machine, such as bearings, chains, gears, etc., to reduce friction and wear and prolong the service life.
4. Regularly check the working parameters of the blow molding machine, such as temperature, pressure, flow, etc., whether they meet the standard requirements, and adjust and optimize in time.
5. Regularly check the safety devices of the blow molding machine, such as limit switches, emergency stop buttons, fuses, etc., whether they are effective and reliable, and test and replace them in time.
The problems and solutions that may be encountered during the use of BOTTLE BLOWING MACHINE are mainly as follows:
• The bottle is always pinched: it may be that the position of the manipulator is misplaced, and the position and angle of the manipulator need to be readjusted.
• Two manipulators collide: there may be a problem with the synchronization of the manipulators. It is necessary to manually reset the manipulators and check whether the synchronization sensor is working normally.
• The bottle cannot be taken out of the mold after blowing: it may be that the exhaust time setting is unreasonable or the exhaust valve is faulty. It is necessary to check whether the exhaust time setting meets the standard requirements, and open the exhaust valve to check the condition of its spring and seal.
• Feeding is old and stuck in the feed tray: It may be that the inclination angle of the feed tray is not suitable or there are foreign objects on the feed tray. It is necessary to adjust the inclination angle of the feed tray and clean the foreign objects on the feed tray.
• There is no feeding at the feeding level of the blow molding machine: it may be that the hopper is out of material or the control contactor of the elevator is not powered on. It is necessary to add materials quickly and check whether the control contactor of the elevator is working normally.
Post time: Jul-25-2023